Vinyl Sticker Help

Vinyl stickers are easy to apply or easy to screw up, depending on how much time you take to prep the install area and follow directions.  As all vinyl stickers typically use the same process, there is a video below to help explain how to get this sucker on first time and make sure it stays that way.

NOTE: We haven't had anyone contact us asking for a new sticker because our instructions were wrong, please don't be the first. 

STUFF YOU MIGHT NEED

STEP 1 - PREP

Clean the area thoroughly with rubbing alcohol or soap and water. Do not use a glass cleaner because it will leave a residue behind that will prevent the sticker from adhering well.

STEP 2 - RUB THE STICKER FRONT

Rub a squeegee or credit card firmly across the sticker through the clear transfer tape to prepare it for application. This ensures the sticker will cling to the transfer tape and removes any air bubbles that may have formed.

STEP 3 - PULL THE BACKING PAPER

Peel the white paper backing off the sticker. If the sticker clings to the backing, slowly replace the paper backing and repeat Step 2.  You can also use masking tape to keep the transfer tape in your original location (blue tape).

STEP 4 - SLOWLY LOWER STICKER

Slowly lower the sticker onto the surface and rub it in place firmly with a squeegee or credit card. For best results, wait 24 hours before moving to the next step.

STEP 5 - PEEL TRANSFER TAPE

Slowly peel the clear transfer tape off at an angle. Be careful not to pull the sticker off the surface. If sticker pulls away from the surface repeat Step 4.